Behringer Virtualizer Pro DSP1024P Manual de usuario descargar pdf (Pagina 25)

VIRTUALIZER PRO DSP1024P

Unbalanced use of

mono 1/4" jack plugs

Ring

Balanced use of

stereo 1/4" jack plugs

Balanced use with XLR connectors

1 2

2 1

Input

Output

Tip =

Signal

Tip =

hot (+ve)

Sleeve =

Ground / Shield

Sleeve =

Ground / Shield

Tip

Sleeve

Strain relief clamp

Ring =

cold (-ve)

For connection of balanced and

unbalanced plugs, ring and sleeve have

to be bridged at the stereo plug.

1 = Ground / Shield

2 = hot (+ve)

3 = cold (-ve)

For unbalanced use pin 1 and pin 3 have to be bridged

Fig. 5.1: Different plug types

5.3 MIDI connections

The MIDI standard was developed in the early 1980s to allow electronic musical instruments from different

manufacturers to communicate with each other. The use of MIDI has developed over the intervening years to

the stage where it is now common to find complete recording studios operating entirely on a MIDI basis. The

centerpiece in such a studio is usually a computer running a sequencer software which not only controls

various keyboards, samplers and sound modules, but can also run the programming of outboard effect devices,

typically digital reverberation and delay units. The VIRTUALIZER PRO may be controlled in real time in this

studio environment.

 MIDI for Musical Instruments Digital Interface.

The MIDI connectors found on the rear panel are of the universally used 5 pin DIN type. You require suitable

MIDI cables to connect the VIRTUALIZER PRO to other MIDI devices. Normally complete cables will be

purchased for this use, you can of course make your own, using a high quality cable with two cores and

shielding (like microphone cable), with as connectors two good 180 degree DIN plugs. Pin 2 (center) is

connected to the cable’s shield, pins 4 and 5 (left and right next to 2) carry the two cores, pins 1 and 3 are not

used. MIDI cables should have a maximum length not exceeding 45 feet.

MIDI IN: This connector is used to receive MIDI control data on the receive channel set in the SETUP menu.

MIDI THRU: The MIDI THRU jack allows you to loop through incoming MIDI signals without modification, for

instance, to daisy-chain several VIRTUALIZER PRO’s.

MIDI OUT: Use the MIDI OUT to send data to a connected computer or other VIRTUALIZER PRO. The DSP1024P

transmits both program data and status information for signal processing.

5. INSTALLATION

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31

Comentarios a estos manuales

Sin comentarios

Behringer Virtualizer Pro DSP1024P Manual de usuario Pagina 25

Comentarios a estos manuales

Relacionado con productos y manuales para Ecualizadores de audio Behringer Virtualizer Pro DSP1024P